| Step | | Procedure & Parts & Tools |
| 1 |
|
PULL TO REMOVE THE RED CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 2 |
|
PULL TO REMOVE THE BLUE CAPPED HOSE FROM MACHINE. PLACE HOSE NEAR DRAIN AND REMOVE CAP
|
| 3 |
|
LOCATE YELLOW CAP ON SOLUTION FILTER
|
| 4 |
|
TURN CAP AND PULL TO REMOVE SOLUTION FILTER
|
| 5 |
|
REMOVE THE 2 SCREWS HOLDING SOLENOID VALVE ASSEMBLY TO MACHINE
| Screwdriver-phillips |
|
|
| 6 |
|
PULL THE SOLENOID VALVE ASSEMBLY THRU WALL OF MACHINE
|
| 7 |
|
PULL THE SOLENOID VALVE ASSEMBLY FROM UNDER THE MACHINE
|
| 8 |
|
LOCATE 2 BLACK WIRES ON SOLENOID VALVE. PULL WIRE CONNECTORS TO DISCONNECT THE WIRES
|
| 9 |
|
INSERT PROBES OF VOLT METER INTO THE 2 BLACK WIRES
| Volt meter (True RMS capable) |
&Width=100)
|
|
| 10 |
|
TURN THE KEY TO THE ON POSITION. PRESS THE SOLUTION BUTTON ON THE CONTROL PANEL TO TURN THE SOLUTION ON.
|
| 11 |
|
LOWER THE BRUSH DECK WITH THE FOOT PEDAL
|
| 12 |
|
USE THE BOTTOM SINGLE LEVER TO LOWER THE HANDLE. PUSH THE TOP 2 LEVERS TO ENGAGE THE BRUSHES.
|
| 13 |
|
WITH BRUSHES RUNNING, CHECK THE READING ON THE VOLT METER. THE READING SHOULD BE 24 VOLTS OR NEG 24V (DOESN'T MATTER IF VOLT METER READS NEG 24V, JUST MEANS PROBES ARE SWITCHED)
| Volt meter (True RMS capable) |
|
|
| 14 |
|
REVERSE STEPS 3 THRU 8 TO REASSEMBLE THE SOLENOID VALVE AND SOLUTION FILTER.
| Screwdriver-phillips |
|
|